View source for B-flat bootlog2

 Starting kernel ...
 
 Linux version 2.6.21 (otto@otto) (gcc version 4.1.2) #1 Mon May 12 10:24:19 PDT 2008
 CPU: XScale-PXA270 [69054117] revision 7 (ARMv5TE), cr=0000397f
 Machine: The Gumstix Platform
 Memory policy: ECC disabled, Data cache writeback
 Run Mode clock: 208.00MHz (*16)
 Turbo Mode clock: 416.00MHz (*2.0, active)
 Memory clock: 104.00MHz (/2)
 System bus clock: 104.00MHz
 CPU0: D VIVT undefined 5 cache
 CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
 CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
 Built 1 zonelists.  Total pages: 16256
 Kernel command line: console=ttyS0,115200n8 root=1f01 rootfstype=jffs2 reboot=cold,hard
 PID hash table entries: 256 (order: 8, 1024 bytes)
 Console: colour dummy device 80x30
 Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
 Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
 Memory: 64MB = 64MB total
 Memory: 62720KB available (1808K code, 196K data, 148K init)
 Mount-cache hash table entries: 512
 CPU: Testing write buffer coherency: ok
 NET: Registered protocol family 16
 NET: Registered protocol family 2
 Time: pxa_timer clocksource has been installed.
 IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
 TCP established hash table entries: 2048 (order: 2, 16384 bytes)
 TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
 TCP: Hash tables configured (established 2048 bind 2048)
 TCP reno registered
 JFFS2 version 2.2. (NAND) (SUMMARY)  (C) 2001-2006 Red Hat, Inc.
 io scheduler noop registered
 io scheduler cfq registered (default)
 Console: switching to colour frame buffer device 80x24
 pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART
 pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART
 pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART
 Probing Gumstix Flash ROM at physical address 0x00000000 (16-bit bankwidth)
 Gumstix Flash ROM: Found 1 x16 devices at 0x0 in 16-bit bank
  Intel/Sharp Extended Query Table at 0x010A
  Intel/Sharp Extended Query Table at 0x010A
  Intel/Sharp Extended Query Table at 0x010A
  Intel/Sharp Extended Query Table at 0x010A
  Intel/Sharp Extended Query Table at 0x010A
 Using buffer write method
 cfi_cmdset_0001: Erase suspend on write enabled
 Using static partitions on Gumstix Flash ROM
 Creating 3 MTD partitions on "Gumstix Flash ROM":
 0x00000000-0x00040000 : "Bootloader"
 0x00040000-0x00f00000 : "RootFS"
 0x00f00000-0x01000000 : "Kernel"
 TCP cubic registered
 NET: Registered protocol family 1
 NET: Registered protocol family 17
 XScale iWMMXt coprocessor detected.
 VFS: Mounted root (jffs2 filesystem).
 Freeing init memory: 148K
 INIT: version 2.86 booting
 Starting the hotplug events dispatcher udevd
 Synthesizing the initial hotplug events
 Remounting root file system...
 gumstix_smc91x_init: smc91x chip not found, returning -ENXIO
 smc91x: Unknown symbol gumstix_smc91x_load
 Invalid chip endian 0x080
 smc911x: not found (-19).
 Bluetooth: Core ver 2.11
 NET: Registered protocol family 31
 Bluetooth: HCI device and connection manager initialized
 Bluetooth: HCI socket layer initialized
 Bluetooth: L2CAP ver 2.8
 Bluetooth: L2CAP socket layer initialized
 Bluetooth: HIDP (Human Interface Emulation) ver 1.2
 usbcore: registered new interface driver usbfs
 usbcore: registered new interface driver hub
 usbcore: registered new device driver usb
 pxa27x-ohci pxa27x-ohci: PXA27x OHCI
 pxa27x-ohci pxa27x-ohci: new USB bus registered, assigned bus number 1
 pxa27x-ohci pxa27x-ohci: irq 3, io mem 0x4c000000
 usb usb1: configuration #1 chosen from 1 choice
 hub 1-0:1.0: USB hub found
 hub 1-0:1.0: 3 ports detected
 Not netCF-vx board: using newer GPIO configuration
 CPLD responded with: ff
 Bluetooth: RFCOMM socket layer initialized
 Bluetooth: RFCOMM TTY layer initialized
 Bluetooth: RFCOMM ver 1.8
 root: mount: special device /dev/hda1 does not exist
 root: mount: special device /dev/mmcblk0p1 does not exist
 root: mount: special device /dev/sda1 does not exist
 Setting up IP spoofing protection: rp_filter.
 Configuring network interfaces... SIOCGIFFLAGS: No such device
 eth0      No such device 
 udhcpc (v1.2.1) started
 udhcpc[572]: udhcpc (v1.2.1) started
 SIOCGIFINDEX failed!: No such device
 udhcpc[572]: SIOCGIFINDEX failed!: No such device
 done.
 Nothing to be done
 INIT: Entering runlevel: 5
 Starting Dropbear SSH server: dropbear.
 Starting HTTP server: boagethostbyname:: Resource temporarily unavailable
 Starting system message bus: dbus.
 Starting ntpd: done
 Starting syslogd/klogd: done
 Starting 32kHz clock...Settled
 Starting Bluetooth subsystem:
 Trying baud rate 921600...
 No response after reset
 Got Startup Event -- retrying once
 Detected bluetooth module at 921600 baud
 Got: status=0x00, hci_ver=0x03, hci_rev=0x62b9, lmp_ver=0x03, manuf=0x0009, lmp_subver=0x62b9
 Bluetooth: HCI UART driver ver 2.2
 Bluetooth: HCI H4 protocol initialized
  ttyS1 hcidBluetooth: BNEP (Ethernet Emulation) ver 1.2
  pand.
 ALSA: loading sound modules...
 ASoC version 0.13.0
 AC97 SoC Audio Codec 0.6
 asoc: AC97 HiFi <-> pxa2xx-ac97 mapping ok
 pxa2xx_ac97_cold_reset: cold reset timeout (GSR=0x0)
 pxa2xx_ac97_read: read error (ac97_reg=7c GSR=0x444)
 pxa2xx_ac97_read: read error (ac97_reg=7e GSR=0x444)
 AC'97 0 access is not valid [0xffffffff], removing mixer.
 soc-audio: probe of soc-audio failed with error -5
 ALSA: Restoring mixer settings...
 /usr/sbin/alsactl: load_state:1329: No soundcards found...
 Running ntpdate to synchronize clockError : Temporary failure in name resolution
 .
 Starting bonjour:
 Starting Vixie-cron.
 Starting i2c...
 tsc2003 i2c touch screen controller
 tsc2003_i2c_detect: probing address 0x48
 input: tsc2003 as /class/input/input0
 tsc2003 - registering input device
 tsc2003_i2c_detect: device address 0x48 attached.
 I2C: i2c-0: PXA I2C adapter
 tsc2003 i2c touch screen controller
 tsc2003_i2c_detect: probing address 0x48
 i2c: error: timeout
 i2c: msg_num: 1 msg_idx: 0 msg_ptr: 1
 i2c: ICR: 000017ee ISR: 00000005
 i2c: log: [00000045:000017e8] [00000085:000017ee]
 I2C: i2c-1: PXA I2C adapter
 i2c /dev entries driver 
 
 OpenEmbedded Linux regina ttyS0
 
 Angstrom 2007.9-test-20080512 regina ttyS0
 
 regina login: