Difference between revisions of "Category:How to - wifi"

Latest revision as of 16:52, 9 February 2009

The wifi configuration file is located in /etc/network/interfaces

The following 2 pages are in this category, out of 2 total.

@@ Line 2: / Line 2: @@
 The wifi configuration file is located in
 <code>/etc/network/interfaces</code>
-== Creating an Ad-hoc Network ==
-'''On startup using the interfaces file:'''
-Open <code>/etc/network/interfaces</code>
-Change the wlan0 config to
-<code><pre>
-auto wlan0
-iface wlan0 inet static
-address 192.168.2.2
-netmask 255.255.255.0
-wireless-mode ad-hoc
-wireless-essid gumstix-network
-</pre></code>
-Reboot
-'''Using ifconfig and iwconfig:'''
-<code><pre>
-ifconfig wlan0 down
-ifconfig wlan0 address 192.168.2.2 netmask 255.255.255.0
-iwconfig wlan0 mode ad-hoc essid gumstix-network
-ifconfig wlan0 up
-</pre></code>
-== Running DHCP Server on Ad-hoc Network==
-Setting up a DHCP server on the ad-hoc network will allow you to connect to the gumstix without having to change your ip address.
-Create a configuration file:
-<code>vi /etc/udhcpd.conf </code>
-Put the following in the file:
-<code><pre>
-#start address
-start           192.168.2.3
-#end address
-end             192.168.2.254
-#interface to listen on
-interface       wlan0
-#maximum number of leases
-max_leases      64
-</pre></code>
-Now run the dhcp server:
-<code>udhcpd /etc/udhcpd.conf</code>
-Connect to the gumstix ad-hoc network and you should notice that you have been assigned the start address in the config file above.