Difference between revisions of "B-flat bootlog2"
From Gumstix User Wiki
(New page: Starting kernel ... Linux version 2.6.21 (otto@otto) (gcc version 4.1.2) #1 Mon May 12 10:24:19 PDT 2008 CPU: XScale-PXA270 [69054117] revision 7 (ARMv5TE), cr=0000397f Machine: The ...) |
Searchworks (Talk | contribs) (remove spam) |
(One intermediate revision by one other user not shown) | |
(No difference)
|
Latest revision as of 22:18, 10 November 2010
Starting kernel ... Linux version 2.6.21 (otto@otto) (gcc version 4.1.2) #1 Mon May 12 10:24:19 PDT 2008 CPU: XScale-PXA270 [69054117] revision 7 (ARMv5TE), cr=0000397f Machine: The Gumstix Platform Memory policy: ECC disabled, Data cache writeback Run Mode clock: 208.00MHz (*16) Turbo Mode clock: 416.00MHz (*2.0, active) Memory clock: 104.00MHz (/2) System bus clock: 104.00MHz CPU0: D VIVT undefined 5 cache CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets Built 1 zonelists. Total pages: 16256 Kernel command line: console=ttyS0,115200n8 root=1f01 rootfstype=jffs2 reboot=cold,hard PID hash table entries: 256 (order: 8, 1024 bytes) Console: colour dummy device 80x30 Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 64MB = 64MB total Memory: 62720KB available (1808K code, 196K data, 148K init) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 NET: Registered protocol family 2 Time: pxa_timer clocksource has been installed. IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered JFFS2 version 2.2. (NAND) (SUMMARY) (C) 2001-2006 Red Hat, Inc. io scheduler noop registered io scheduler cfq registered (default) Console: switching to colour frame buffer device 80x24 pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART Probing Gumstix Flash ROM at physical address 0x00000000 (16-bit bankwidth) Gumstix Flash ROM: Found 1 x16 devices at 0x0 in 16-bit bank Intel/Sharp Extended Query Table at 0x010A Intel/Sharp Extended Query Table at 0x010A Intel/Sharp Extended Query Table at 0x010A Intel/Sharp Extended Query Table at 0x010A Intel/Sharp Extended Query Table at 0x010A Using buffer write method cfi_cmdset_0001: Erase suspend on write enabled Using static partitions on Gumstix Flash ROM Creating 3 MTD partitions on "Gumstix Flash ROM": 0x00000000-0x00040000 : "Bootloader" 0x00040000-0x00f00000 : "RootFS" 0x00f00000-0x01000000 : "Kernel" TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 XScale iWMMXt coprocessor detected. VFS: Mounted root (jffs2 filesystem). Freeing init memory: 148K INIT: version 2.86 booting Starting the hotplug events dispatcher udevd Synthesizing the initial hotplug events Remounting root file system... gumstix_smc91x_init: smc91x chip not found, returning -ENXIO smc91x: Unknown symbol gumstix_smc91x_load Invalid chip endian 0x080 smc911x: not found (-19). Bluetooth: Core ver 2.11 NET: Registered protocol family 31 Bluetooth: HCI device and connection manager initialized Bluetooth: HCI socket layer initialized Bluetooth: L2CAP ver 2.8 Bluetooth: L2CAP socket layer initialized Bluetooth: HIDP (Human Interface Emulation) ver 1.2 usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb pxa27x-ohci pxa27x-ohci: PXA27x OHCI pxa27x-ohci pxa27x-ohci: new USB bus registered, assigned bus number 1 pxa27x-ohci pxa27x-ohci: irq 3, io mem 0x4c000000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 3 ports detected Not netCF-vx board: using newer GPIO configuration CPLD responded with: ff Bluetooth: RFCOMM socket layer initialized Bluetooth: RFCOMM TTY layer initialized Bluetooth: RFCOMM ver 1.8 root: mount: special device /dev/hda1 does not exist root: mount: special device /dev/mmcblk0p1 does not exist root: mount: special device /dev/sda1 does not exist Setting up IP spoofing protection: rp_filter. Configuring network interfaces... SIOCGIFFLAGS: No such device eth0 No such device udhcpc (v1.2.1) started udhcpc[572]: udhcpc (v1.2.1) started SIOCGIFINDEX failed!: No such device udhcpc[572]: SIOCGIFINDEX failed!: No such device done. Nothing to be done INIT: Entering runlevel: 5 Starting Dropbear SSH server: dropbear. Starting HTTP server: boagethostbyname:: Resource temporarily unavailable Starting system message bus: dbus. Starting ntpd: done Starting syslogd/klogd: done Starting 32kHz clock...Settled Starting Bluetooth subsystem: Trying baud rate 921600... No response after reset Got Startup Event -- retrying once Detected bluetooth module at 921600 baud Got: status=0x00, hci_ver=0x03, hci_rev=0x62b9, lmp_ver=0x03, manuf=0x0009, lmp_subver=0x62b9 Bluetooth: HCI UART driver ver 2.2 Bluetooth: HCI H4 protocol initialized ttyS1 hcidBluetooth: BNEP (Ethernet Emulation) ver 1.2 pand. ALSA: loading sound modules... ASoC version 0.13.0 AC97 SoC Audio Codec 0.6 asoc: AC97 HiFi <-> pxa2xx-ac97 mapping ok pxa2xx_ac97_cold_reset: cold reset timeout (GSR=0x0) pxa2xx_ac97_read: read error (ac97_reg=7c GSR=0x444) pxa2xx_ac97_read: read error (ac97_reg=7e GSR=0x444) AC'97 0 access is not valid [0xffffffff], removing mixer. soc-audio: probe of soc-audio failed with error -5 ALSA: Restoring mixer settings... /usr/sbin/alsactl: load_state:1329: No soundcards found... Running ntpdate to synchronize clockError : Temporary failure in name resolution . Starting bonjour: Starting Vixie-cron. Starting i2c... tsc2003 i2c touch screen controller tsc2003_i2c_detect: probing address 0x48 input: tsc2003 as /class/input/input0 tsc2003 - registering input device tsc2003_i2c_detect: device address 0x48 attached. I2C: i2c-0: PXA I2C adapter tsc2003 i2c touch screen controller tsc2003_i2c_detect: probing address 0x48 i2c: error: timeout i2c: msg_num: 1 msg_idx: 0 msg_ptr: 1 i2c: ICR: 000017ee ISR: 00000005 i2c: log: [00000045:000017e8] [00000085:000017ee] I2C: i2c-1: PXA I2C adapter i2c /dev entries driver OpenEmbedded Linux regina ttyS0 Angstrom 2007.9-test-20080512 regina ttyS0 regina login: