New 60pin connector chart
From Gumstix User Wiki
You can check if this connector is on your gumstix by using the reference table on the Gumstix motherboard I/O page.
Note: Schematic images and charts below are from the point of view of the gumstix looking at the connector from the daughtercard's point of view, these signals are mirrored^
Signal | GPIO | Pin | Signal | GPIO | Pin |
---|---|---|---|---|---|
GND | 1 | GND | 60 | ||
L_DD(9) | GPIO(67) | 2 | USB_N | 59 | |
L_BIAS | GPIO(77) | 3 | BITCLK | GPIO(28) | 58 |
L_DD(3) | GPIO(61) | 4 | L_PCLK | GPIO(76) | 57 |
SDATA_OUT | GPIO(30) | 5 | L_DD(15) | GPIO(73) | 56 |
L_DD(8) | GPIO(66) | 6 | L_DD(14) | GPIO(72) | 55 |
GND | 7 | FFRXD | GPIO(34) | 54 | |
L_DD(13) | GPIO(71) | 8 | L_DD(7) | GPIO(65) | 53 |
L_DD(12) | GPIO(70) | 9 | L_DD(5) | GPIO(63) | 52 |
L_DD(11) | GPIO(69) | 10 | L_DD(10) | GPIO(68) | 51 |
USB_P | 11 | L_DD(1) | GPIO(59) | 50 | |
IRRXD | GPIO(46) | 12 | NACRESET | 49 | |
L_DD(2) | GPIO(60) | 13 | IR_TXD | GPIO(47) | 48 |
FFCTS | GPIO(35) | 14 | L_DD(4) | GPIO(62) | 47 |
SDATA_IN1 | GPIO(32) | 15 | SYNC | GPIO(31) | 46 |
L_LCLK | GPIO(75) | 16 | NSSP_RXD | GPIO(84) | 45 |
PWM(1) | GPIO(17) | 17 | NSSP_FRAME | GPIO(82) | 44 |
L_DD(0) | GPIO(58) | 18 | SDATA_IN0 | GPIO(29) | 43 |
I2C_SDA | 19 | GND | 42 | ||
I2C_SCL | 20 | L_FCLK | GPIO(74) | 41 | |
NSSP_CLK | GPIO(81) | 21 | L_DD(6) | GPIO(64) | 40 |
BT_RXD | GPIO(42) | 22 | FFRTS | GPIO(41) | 39 |
NSSP_TXD | GPIO(83) | 23 | DRQ0 | GPIO(20) | 38 |
BT_CTS | GPIO(44) | 24 | NRESET | 37 | |
BT_TXD | GPIO(43) | 25 | PWM(0) | GPIO(16) | 36 |
FFTXD | GPIO(39) | 26 | HWTXD | GPIO(48) | 35 |
BT_RTS | GPIO(45) | 27 | HWRTS | GPIO(51) | 34 |
V_BATT | 28 | HWRXD | GPIO(49) | 33 | |
V_BATT | 29 | HWCTS | GPIO(50) | 32 | |
V_BATT | 30 | GND | 31 |