B-flat bootlog2

Starting kernel ...

Linux version 2.6.21 (otto@otto) (gcc version 4.1.2) #1 Mon May 12 10:24:19 PDT 2008
CPU: XScale-PXA270 [69054117] revision 7 (ARMv5TE), cr=0000397f
Machine: The Gumstix Platform
Memory policy: ECC disabled, Data cache writeback
Run Mode clock: 208.00MHz (*16)
Turbo Mode clock: 416.00MHz (*2.0, active)
Memory clock: 104.00MHz (/2)
System bus clock: 104.00MHz
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists.  Total pages: 16256
Kernel command line: console=ttyS0,115200n8 root=1f01 rootfstype=jffs2 reboot=cold,hard
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 62720KB available (1808K code, 196K data, 148K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
NET: Registered protocol family 2
Time: pxa_timer clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
JFFS2 version 2.2. (NAND) (SUMMARY)  (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler cfq registered (default)
Console: switching to colour frame buffer device 80x24
pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART
pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART
pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART
Probing Gumstix Flash ROM at physical address 0x00000000 (16-bit bankwidth)
Gumstix Flash ROM: Found 1 x16 devices at 0x0 in 16-bit bank
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
Using static partitions on Gumstix Flash ROM
Creating 3 MTD partitions on "Gumstix Flash ROM":
0x00000000-0x00040000 : "Bootloader"
0x00040000-0x00f00000 : "RootFS"
0x00f00000-0x01000000 : "Kernel"
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
XScale iWMMXt coprocessor detected.
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 148K
INIT: version 2.86 booting
Starting the hotplug events dispatcher udevd
Synthesizing the initial hotplug events
Remounting root file system...
gumstix_smc91x_init: smc91x chip not found, returning -ENXIO
smc91x: Unknown symbol gumstix_smc91x_load
Invalid chip endian 0x080
smc911x: not found (-19).
Bluetooth: Core ver 2.11
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP ver 2.8
Bluetooth: L2CAP socket layer initialized
Bluetooth: HIDP (Human Interface Emulation) ver 1.2
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
pxa27x-ohci pxa27x-ohci: PXA27x OHCI
pxa27x-ohci pxa27x-ohci: new USB bus registered, assigned bus number 1
pxa27x-ohci pxa27x-ohci: irq 3, io mem 0x4c000000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
Not netCF-vx board: using newer GPIO configuration
CPLD responded with: ff
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM ver 1.8
root: mount: special device /dev/hda1 does not exist
root: mount: special device /dev/mmcblk0p1 does not exist
root: mount: special device /dev/sda1 does not exist
Setting up IP spoofing protection: rp_filter.
Configuring network interfaces... SIOCGIFFLAGS: No such device
eth0      No such device 
udhcpc (v1.2.1) started
udhcpc[572]: udhcpc (v1.2.1) started
SIOCGIFINDEX failed!: No such device
udhcpc[572]: SIOCGIFINDEX failed!: No such device
done.
Nothing to be done
INIT: Entering runlevel: 5
Starting Dropbear SSH server: dropbear.
Starting HTTP server: boagethostbyname:: Resource temporarily unavailable
Starting system message bus: dbus.
Starting ntpd: done
Starting syslogd/klogd: done
Starting 32kHz clock...Settled
Starting Bluetooth subsystem:
Trying baud rate 921600...
No response after reset
Got Startup Event -- retrying once
Detected bluetooth module at 921600 baud
Got: status=0x00, hci_ver=0x03, hci_rev=0x62b9, lmp_ver=0x03, manuf=0x0009, lmp_subver=0x62b9
Bluetooth: HCI UART driver ver 2.2
Bluetooth: HCI H4 protocol initialized
 ttyS1 hcidBluetooth: BNEP (Ethernet Emulation) ver 1.2
 pand.
ALSA: loading sound modules...
ASoC version 0.13.0
AC97 SoC Audio Codec 0.6
asoc: AC97 HiFi <-> pxa2xx-ac97 mapping ok
pxa2xx_ac97_cold_reset: cold reset timeout (GSR=0x0)
pxa2xx_ac97_read: read error (ac97_reg=7c GSR=0x444)
pxa2xx_ac97_read: read error (ac97_reg=7e GSR=0x444)
AC'97 0 access is not valid [0xffffffff], removing mixer.
soc-audio: probe of soc-audio failed with error -5
ALSA: Restoring mixer settings...
/usr/sbin/alsactl: load_state:1329: No soundcards found...
Running ntpdate to synchronize clockError : Temporary failure in name resolution
.
Starting bonjour:
Starting Vixie-cron.
Starting i2c...
tsc2003 i2c touch screen controller
tsc2003_i2c_detect: probing address 0x48
input: tsc2003 as /class/input/input0
tsc2003 - registering input device
tsc2003_i2c_detect: device address 0x48 attached.
I2C: i2c-0: PXA I2C adapter
tsc2003 i2c touch screen controller
tsc2003_i2c_detect: probing address 0x48
i2c: error: timeout
i2c: msg_num: 1 msg_idx: 0 msg_ptr: 1
i2c: ICR: 000017ee ISR: 00000005
i2c: log: [00000045:000017e8] [00000085:000017ee]
I2C: i2c-1: PXA I2C adapter
i2c /dev entries driver 

OpenEmbedded Linux regina ttyS0

Angstrom 2007.9-test-20080512 regina ttyS0

regina login: