Difference between revisions of "UARTs"
From Gumstix User Wiki
(New page: * Logic level (3.3V) signals * FFUART speeds to 230 kbps (normally mapped to ttyS0 in the kernel and Y0 in some schematics ) * HWUART speeds to 921 kbps (normally mapped to ttyS3 in the ...) |
|||
| Line 7: | Line 7: | ||
* Note! Current kernels use ttyS3 (HWUART) for bluetooth. This is available on the BTUART pins by setting GPIO42 and 43 to AF3 - and this is the default configuration. This can be very confusing if you want to use the HWUART for something else! To re-enable HWUART on ttyS3, make bluetooth use ttyS1 (see /etc/default/bluetooth) and then set GPIO42 to AF1 in and GPIO43 to AF2 out. You can then set GPIO48 to AF1 out (HWUART TXD) and GPIO49 to AF1 in (HWUART RXD). | * Note! Current kernels use ttyS3 (HWUART) for bluetooth. This is available on the BTUART pins by setting GPIO42 and 43 to AF3 - and this is the default configuration. This can be very confusing if you want to use the HWUART for something else! To re-enable HWUART on ttyS3, make bluetooth use ttyS1 (see /etc/default/bluetooth) and then set GPIO42 to AF1 in and GPIO43 to AF2 out. You can then set GPIO48 to AF1 out (HWUART TXD) and GPIO49 to AF1 in (HWUART RXD). | ||
| + | |||
| + | |||
| + | |||
| + | http://docwiki.gumstix.org/Gumstix_UARTs | ||
Revision as of 06:33, 14 March 2008
- Logic level (3.3V) signals
- FFUART speeds to 230 kbps (normally mapped to ttyS0 in the kernel and Y0 in some schematics )
- HWUART speeds to 921 kbps (normally mapped to ttyS3 in the kernel and Y1 in some schematics)
- Both can use RxD, TxD, RTS, CTS.
- STUART speeds to 230 kbps (normally mapped to ttyS2)
- BTUART is not an exposed interface; mapped to ttyS1 by the kernel and connected physically to the bluetooth module if one is present.
- Note! Current kernels use ttyS3 (HWUART) for bluetooth. This is available on the BTUART pins by setting GPIO42 and 43 to AF3 - and this is the default configuration. This can be very confusing if you want to use the HWUART for something else! To re-enable HWUART on ttyS3, make bluetooth use ttyS1 (see /etc/default/bluetooth) and then set GPIO42 to AF1 in and GPIO43 to AF2 out. You can then set GPIO48 to AF1 out (HWUART TXD) and GPIO49 to AF1 in (HWUART RXD).
