Difference between revisions of "UARTs"

From Gumstix User Wiki
Jump to: navigation, search
Line 16: Line 16:
  
 
=== FFUART ===
 
=== FFUART ===
 +
 +
 +
{| border="1" cellpadding="5" cellspacing="0" style="width:100px"
 +
|-
 +
| style="background:lightblue;" | FF_CTS
 +
|-
 +
| style="background:lightblue;" | FF_RTS
 +
|-
 +
| style="background:lightblue;" | FF_TXD
 +
|-
 +
| style="background:lightblue;" | FF_RXD
 +
|}
 +
 +
Logic level (3.3V) signals
 +
FFUART speeds to 230 kbps (normally mapped to ttyS0 in the kernel and Y0 in some schematics )
 +
FFUART pins are located on the [[60pin connector|60-pin Hirose connector]]
  
  

Revision as of 15:11, 14 March 2008

  • Logic level (3.3V) signals
  • FFUART speeds to 230 kbps (normally mapped to ttyS0 in the kernel and Y0 in some schematics )
  • HWUART speeds to 921 kbps (normally mapped to ttyS3 in the kernel and Y1 in some schematics)
  • Both can use RxD, TxD, RTS, CTS.
  • STUART speeds to 230 kbps (normally mapped to ttyS2)
  • BTUART is not an exposed interface; mapped to ttyS1 by the kernel and connected physically to the bluetooth module if one is present.
  • Note! Current kernels use ttyS3 (HWUART) for bluetooth. This is available on the BTUART pins by setting GPIO42 and 43 to AF3 - and this is the default configuration. This can be very confusing if you want to use the HWUART for something else! To re-enable HWUART on ttyS3, make bluetooth use ttyS1 (see /etc/default/bluetooth) and then set GPIO42 to AF1 in and GPIO43 to AF2 out. You can then set GPIO48 to AF1 out (HWUART TXD) and GPIO49 to AF1 in (HWUART RXD).


http://docwiki.gumstix.org/Gumstix_UARTs

UARTs

FFUART

FF_CTS
FF_RTS
FF_TXD
FF_RXD

Logic level (3.3V) signals FFUART speeds to 230 kbps (normally mapped to ttyS0 in the kernel and Y0 in some schematics ) FFUART pins are located on the 60-pin Hirose connector


HWUART

STUART

BTUART