Difference between revisions of "UARTs"

From Gumstix User Wiki
Jump to: navigation, search
Line 55: Line 55:
  
  
* HWUART speeds to 921 kbps (normally mapped to ttyS3 in the kernel and Y1 in some schematics)
+
* Logic level (3.3V) signals
 +
* Speeds to 921 kbps
 +
* Normally mapped to ttyS3 in the kernel and Y1 in some schematics
 
* HWUART pins are located on the [[60pin connector|60-pin Hirose]] (Connex and Basix only)  
 
* HWUART pins are located on the [[60pin connector|60-pin Hirose]] (Connex and Basix only)  
 
  
 
<br>
 
<br>

Revision as of 15:28, 14 March 2008

  • Logic level (3.3V) signals
  • FFUART speeds to 230 kbps (normally mapped to ttyS0 in the kernel and Y0 in some schematics )
  • HWUART speeds to 921 kbps (normally mapped to ttyS3 in the kernel and Y1 in some schematics)
  • Both can use RxD, TxD, RTS, CTS.
  • STUART speeds to 230 kbps (normally mapped to ttyS2)
  • BTUART is not an exposed interface; mapped to ttyS1 by the kernel and connected physically to the bluetooth module if one is present.
  • Note! Current kernels use ttyS3 (HWUART) for bluetooth. This is available on the BTUART pins by setting GPIO42 and 43 to AF3 - and this is the default configuration. This can be very confusing if you want to use the HWUART for something else! To re-enable HWUART on ttyS3, make bluetooth use ttyS1 (see /etc/default/bluetooth) and then set GPIO42 to AF1 in and GPIO43 to AF2 out. You can then set GPIO48 to AF1 out (HWUART TXD) and GPIO49 to AF1 in (HWUART RXD).


http://docwiki.gumstix.org/Gumstix_UARTs

UARTs

FFUART


FF_CTS
FF_RTS
FF_TXD
FF_RXD


  • Logic level (3.3V) signals
  • Speeds to 230 kbps
  • Normally mapped to ttyS0 in the kernel and Y0 in some schematics
  • FFUART pins are located on the 60-pin Hirose connector



HWUART


HW_CTS
HW_RTS
HW_TXD
HW_RXD


  • Logic level (3.3V) signals
  • Speeds to 921 kbps
  • Normally mapped to ttyS3 in the kernel and Y1 in some schematics
  • HWUART pins are located on the 60-pin Hirose (Connex and Basix only)



STUART

BTUART


BT_CTS
BT_RTS
BT_TXD
BT_RXD
BT_NRESET


  • BTUART pins are located on the 60-pin Hirose and 24-pin flex ribbon connectors.
  • It is not an exposed interface; mapped to ttyS1 by the kernel and connected physically to the bluetooth module if one is present.